Audio-Technica M3L Advanced Wireless In-Ear Monitor System

Get High Performance You Can Rely On With TheAudio-Technica M3L Advanced Wireless In-Ear Monitor System

Audio-Technicas advanced M3 IEM system offers a full range of professional in-ear monitoring features, with a choice of 1321 UHF channels and easy-to-read LCD information displays on both transmitter and receiver for setting preferences. The stereo monitor system is equipped with Audio-Technicas versatile Personal Mix Control, which allows volume and mix control of two independent signals on stage, via controls on the M3R stereo body-pack receiver. While up to 16 complete M3 systems may be used simultaneously, any number of M3R stereo receivers can operate on the same frequency with a single M3T stereo transmitter. The M3T Stereo Transmitter is equipped with two XLR 1/4″ combo input connectors into which users can connect line-level inputs (from a mixing console, for example). The M3T also offers a headphone output that allows you to monitor transmitter input signals directly.

• High-fidelity sound with clean, articulate mix allows performers to hear themselves clearly at lower volume
• 1321 selectable UHF channels with automatic frequency scanning
• Up to 16 simultaneous systems per frequency band
• Three receiver modes: Personal Mix, stereo, and mono
• Personal Mix Control allows volume and mix control of two independent signals at the receiver
• LCD information display offers step-through menus for setting preferences
• XLR loop output (true pass-through) connects signal to mixing console, additional IEM system or recording device with no signal degradation
• Adjustable squelch eliminates annoying static
• Pilot tone protects against RF interference when transmitter is turned off
• Multi-level limiter (defeatable) helps protect hearing from sudden peaks
• Portable system is quick to load and set up
• Reduces on-stage audio clutter for better overall mix & less feedback
• Use any number of Stereo Receivers (with individual mixes) on the same frequency
• Audio-Technica earphones with proprietary dynamic drivers offer full frequency response and outstanding isolation
• Personal fit with 3 sizes of rubber eartips plus ear-conforming foam tips
• Selectable auxiliary input offers connection point for ambient microphone, click track, or other mic- or line-level input

OVERALL SYSTEM SPECIFICATIONS

• Operating FrequenciesBand L: 575.000 to 608.000 MHz, 1321 frequencies. Not all frequency bands available in all areas. Please check with local regulations.
• Minimum Frequency Step: 25 kHz
• Modulation Mode: FM stereo
• Maximum Deviation: +/- 40 kHz
• Dynamic Range: 90 dB (typical), A-weighted
• Total Harmonic Distortion: <1% at (1 kHz, +/- 20 kHz Deviation)
• Operating Range: 100 m (300′), typical open range environment with no interfering signals.
• Operating Temperature Range: -5 degrees C (23 degrees F) to +50 degrees C (122 degrees F) – Battery performance may be reduced at very low temperatures.
• Frequency Response: 60 Hz to 13 kHz (+/- 3 dB)
• Simultaneous Use16 channels per band (maximum recommended)

RECEIVER SPECIFICATIONS

• Receiving System: Double conversion superheterodyne
• RF Sensitivity: 20 dBuV (at 60 dB S/N ratio, 50 ohms termination)
• Headphone Output Connector: 3.5 mm TRS stereo phone jack
• Headphone Output Power: 65 mW (at 32 ohms)
• Antenna Input: SMA-type, 50 ohms
• Aux Input Connector: 3.5 mm TRS stereo phone jack
• Batteries: 2 x 1.5V AA (not included)
• Battery Life: 8 hours (alkaline) Depending on battery type and use pattern
• Dimensions: 70.0 mm (2.76″) W x 25.0 mm (0.98″) D x 110.0 mm (4.33″) H
• Net Weight: 133 g (4.7 oz), without batteries
• Accessories Included: EP3 earphone; flexible antenna

TRANSMITTER SPECIFICATIONS

• RF Power Output: 10 mW/50 mW (switchable), 50 ohms – Limited to 10 mW within 863 MHz to 865 MHz following national regulations
• Spurious Emissions: Following federal and national regulations
• Input Connections: XLRF-type/6.3 mm stereo (1/4″) combination connector
• Pin 1 and Sleeve: Ground
• Pin 2 and Tip: Hot
• Pin 3 and Ring: Cold
• Maximum Input Level: XLRF-type/6.3 mm stereo, (1/4″) balanced: +26 dBu
• 6.3 mm (1/4″) mono, unbalanced: +26 dBu
• Loop Output Connector: XLRM-type connector
• Pin 1: Ground
• Pin 2: Hot
• Pin 3: Cold
• Power Requirement: 12-18V DC, 600 mA
• Headphone Output Connector: 6.3 mm (1/4″) TRS stereo phone jack
• Headphone Output Power: 120 mW at 32 ohms
• Antenna Connector: BNC, 50 ohms
• Dimensions: 210.0 mm (8.30″) W x 132.0 mm (5.20″) D x 44.0 mm (1.70″) H
• Net Weight: 930 g (32.8 oz), without accessories
• Accessories Included: AC adapter (country dependant); rack mount adapters; flexible antenna

Manufacturer:Audio-Technica
Model:M3L
SKU:I230897-N-0-WHXX
UPC: 736021163621

We are Chuck Levin’s Washington Music Center

Since 1958, Chuck Levins Washington Music Center has been the trusted destination for musicians and audio professionals across Maryland, Virginia, and Washington, D.C. Family-owned and operated, our legendary music store delivers Everything in Musicfrom instruments and recording gear to pro audio, rentals, and repair services.

Our team of musicians and industry experts lives and breathes gear, helping you build the perfect setup for your next performance, studio session, or installation. As an authorized dealer for top brands, we also offer our award-winning CHUCKSCLUSIVE lineexclusive, limited-edition instruments and collaborations recognized with the NAMM Top 100 Dealer Innovation Award for redefining what a music retail experience can be.

Chuck Levins isnt just a storeits a community built by players, engineers, and creators who share a lifelong passion for sound. Stop by our legendary Wheaton, MD showroom or contact us anytime for expert advice, product questions, or the best possible deal on your next piece of gear.